eth Commands
E-DOC-CTC-20080619-0007 v1.0
355
eth bridge vlan ifconfig
Modify bridge interface from virtual LAN.
SYNTAX:
eth bridge vlan ifconfig name = <{default}>
intf = <{OBC|ethport1|ethport2|ethport3|
ethport4|virt|WLAN}>
untagged = <{disabled|enabled}>
where:
name The VLAN name. REQUIRED
intf The bridge interface from the VLAN to configure. REQUIRED
untagged Enable/disable interface as untagged for this
VLAN.
REQUIRED
To Next Page
