Installation
Remove all packaging material before using
the new refrigerator. This includes the foam
base and all adhesive tape holding the
refrigerator accessories both inside and
outside.
Clean both the inside and outside of the
refrigerator with wet cloth (a little
detergent could be added into the warm
water to wash the cloth and then wipe it
again with the clean water);
Prepare an independent two-pole socket
with grounding contact for the refrigerator
and it shall plug directly to electric socket
on wall, and not share a multi-purpose
socket with other electrical appliances;
Do connect grounding wire! The grounding
pole of the socket shall be provided with a
reliable grounding wire.
Open the refrigerator body and take out
the accessory (decorative cover for bottom
beam) and the three screws from the
instruction packaging bag; then install them
into the bottom beam as shown by the
schematic diagram on the right.
The decorative cover for bottom beam is
used as ornament, so you can choose not
to install it. It won't affect the
refrigerator's performance or conditions
no matter whether you install it or not.
Transport and Placing of Your Refrigerator
Transport
Keep upright and avoid squeezing or
vibration during transport. Avoid a slant
angle over 45 degree during handling.
Avoid the door or top cap from being under
excessive stress when moving; otherwise, it
may become deformed.
To Next Page
Loading...
