Placing
Place your refrigerator in a well-ventilated place and keep it from heat source and direct sunlight. DO
NOT place it in any humid or wet place to avoid rust and weakening of insulation effect.
There shall be a space not less than 30 cm from the top of your refrigerator and not less than 10cm
from both sides or the back of the refrigerator to the adjacent walls respectively. This requirement is
good for open and close of refrigerator door and heat emission.
The refrigerator shall be placed on a flat and firm ground (if not flat, you can use the leveling legs for
adjustment).
Keep Your Refrigerator Standing
How long should it be left before plugging in?
DO NOT connect your refrigerator to power supply immediately after it is placed vertically (or laid
down). You should keep it standing for at least 24 hours before turning the power switch on in order
to avoid damage to the refrigeration system and compressor.
Make sure the power wire is not pinned by the refrigerator or other objects to avoid accidents arising
from power cord faults. Please check the voltage scope of your refrigerator against the actual power
supply before switching it on.
Attention
The refrigerator must be disconnected from the source of electrical supply before attempt to
install accessories.
DO NOT use mechanical equipment or other methods to accelerate the defrosting process
except the means recommended by the manufacturer.
DO NOT use any electrical appliances in the food storage compartments except the model
recommended by the manufacture.
The R134a refrigerant and cyclopentane foaming material used in the refrigerator are inflammable.
All waste and discarded refrigerators shall be placed away from open flam and NEVER burn the
refrigerant.
Warm Reminder: Please place food into the drawers. Do not place any food after removing the
drawers.
To Next Page
Loading...
