Why is there condensation around my Thor Kitchen LRG3001U oven?
Condensation around the oven of your Thor Kitchen Ranges is normal, especially if food has a high moisture content or the local climate is humid. Wipe the drops off the control panel. Ensure that cabinetry around the range is moisture-proofed if there is frequent or excessive condensation.
How to use Thor Kitchen LRG3001U Ranges cooktop burners during a power failure?
Yes, the cooktop burners on your Thor Kitchen Ranges can still be used during a power failure. To light them, hold a lighted match to the flame spreader, push in on the control knob, and turn it counterclockwise to LITE. Once the flame is burning around the burner, adjust the heat as needed. If the flame is blown out, immediately turn the knob to OFF, as the burner won't automatically relight and gas may escape.
How to use Thor Kitchen LRG3001U oven during a power failure?
The Thor Kitchen Ranges oven cannot be used until power is restored.
What to do if my Thor Kitchen LRG3001U Ranges burner is sparking but there is no flame?
If your Thor Kitchen Ranges burner is sparking but not igniting, the gas shut-off valve may be in the ‘OFF’ position. Turn the shut-off valve to the ‘ON’ position.
What to do if the flames on my Thor Kitchen Ranges suddenly go out?
If the flames on your Thor Kitchen Ranges have suddenly gone out, it might be because a draft or spill extinguished them. No action is required, as the burner will detect this and automatically relight. However, if there has been a large spill, turn the burners off and clean the burners and sump area.
Why is one of the oven lights not working on my Thor Kitchen LRG3001U?
If one of the oven lights in your Thor Kitchen Ranges isn’t working but the oven still functions, the light bulb might be loose or blown. First, ensure that the bulb is secure in its socket. If it's still not working, replace the bulb. See the instructions for ‘Replacing the oven light bulb’ in the ‘Care and cleaning’ section.
Why do the igniters on my Thor Kitchen LRG3001U spark continuously after the flame ignites?
Continuous sparking after flame ignition in your Thor Kitchen Ranges can be due to reversed power supply polarity or wet/dirty igniters. Have the polarity corrected, and dry or clean the igniters.
What to do if my Thor Kitchen Ranges burner flame goes out at the low setting?
If the burner flame on your Thor Kitchen Ranges goes out at the low setting, it could be due to low gas supply pressure or obstructed air intake holes around the knobs. Contact your gas company to check the gas supply pressure. Also, remove any obstructions around the air intake holes.
What to do if my Thor Kitchen LRG3001U sparking but no flame ignition?
If your Thor Kitchen Ranges is sparking but the flame isn't igniting, check whether the gas shut-off valve is in the ‘OFF’ position. If so, turn the shut-off valve to the ‘ON’ position.
What to do if my Thor Kitchen Ranges burner flame goes out at low setting?
If the burner flame on your Thor Kitchen Ranges goes out when set to low, it could be due to low gas supply pressure. Contact your gas company to check the pressure. Another possible cause is obstructed air intake holes around the knobs, so remove any obstructions.
General| Brand | Thor Kitchen |
|---|---|
| Model | LRG3001U Series |
| Category | Ranges |
| Language | English |
To Next Page
