TROUBLE SHOOTING
PROBLEM REMEDYPOSSIBLE CAUSE
You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
Appliance does
not operate.
Appliance is not connected to a power
supply.
The appliance is turned off.
Tripped circuit breaker or a blown fuse.
The temperature is not set correctly.
The ambient tempreture could require a
lower temperature setting.
The door was opened too often.
The door was not closed completely.
Door is not hermetically sealed.
The condenser is too dirty.
The ventilation opening is blocked or too
dusty.
The room temp is higher than average.
A large amount of food as been added to
the unit.
The door is open too often.
The door is not closed completely.
The door gasket does not seal properly.
The appliance is not properly level.
The door was reversed and not properly
installed.
The gasket is dirty.
The shelves are out of position.
Level the appliance with the adjustable
feet.
check the door hinge and reassemble
correctly.
Clean the door gasket.
check the shelves and refit correctly.
The appliance is not properly leveled.
The appliance is not properly leveled.
Level the appliance with the adjustable
feet
Level the appliance with the adjustable
feet
Connect the appliance
Switch on the appliance
Switch on circuit breaker or replace fuse.
Check the set temperature.
Set a lower temperature.
Do not open the door more often than
necessary.
Close door properly.
Chck the door seal and clean or replace.
Clean the condenser when necessary.
Clear the obstructions and clean the dust.
Put the appliance in a cooler place.
Leave the appliance to work for a while
until the set temp has been reached.
Do not open the door more often than
necessary.
Close door properly.
Check the door seal and clean or replace.
Appliance
is not cold
enough.
Appliance
turns itself
on and off
frequently.
The appliance
seems to make
too much
noise.
The door will
not close
properly.
Vibrations
The rattling noise may come from the flow of the refrigerant, which is normal as each
cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your
appliance. If temp flucuations occur, the contraction and expansion of the inner walls
may cause popping and cracking noises.
To Next Page
Loading...
