INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
INSTALLATION OF YOUR APPLIANCE
SITE PREPARATION
Remove the exterior and interior packing. Before conecting the appliance to the power source, let it
stand upright for approximately 24 hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation. Clean the interior surface with lukewarm water suing a soft
cloth. Install the handle on the door, if it is not already attached (see page 7).
Your outdoor drawers refrigerator have been designed for both built-in and free standing. When built-in,
your refrigerator drawers do not require additional air space for top, side, or rear. The front grill must
NOT be obstructed.
NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating
source. And heat sources may increase electrical consumption. Don’t install in a location where the
temperature will fall below 50°F (10°C). For best performace, do not install the appliance behind a
cabinet door or block the base grille. Avoid locating the unit in moist areas. Plug the appliance into an
exclusive, properly grounded wall outlet.
1. Position the unit on a flat, level surface capable of supporting the entire weight of the unit. Remember
the unit will be significantly heavier once it is fully loaded.
2. Avoid connecting the unit to a GRound Fault interruptor (GFI). GFIs are prone to nuisance tripping
which will cause the unit to shut down. GFIs are generally not used on circuits which power equipment
that must run unattended for long periods of time.
3. The unit must be installed according to your local codes and ordinances.
4. ELECTROCUTION HAZARD!
!
Electrical Grounding Required - This appliance is equipped with a three prong
(grounding) polarized plug for your protection against possible shock hazards.
• NEVER remove the round grounding prong from the plug.
• NEVER use a two-prong grounding adapter.
• NEVER use an extension cord to connect power to the unit.
Where a two-prong wall receptacle is encountered or a longer power cord is required, contact a qualified
electrician to have it replaced in accordance with applicable electrical codes.
To Next Page
Loading...
