.
.
OPERATING YOUR APPLIANCE
It is recommended that you install the appliance in a place where the ambient temperature is between
50°F and 100°F (10°C - 38°C). If the ambient temperature is above or below the recommended
temperatures, the performance of the unit may be affected. For example, placing your unit in extremely
cold or hot conditions may cause interior temperatures to fluctuate. The operating temperature range
may not be reached.
CONTROL PANEL
The setting should operate in the control panel.
1. Functions of each key in the control panel
A. Power Switch: After you plug in the power cord, press power switch for 1 second, appliance will power
on. To turn off the appliance, press power switch and hold it for 3 seconds, appliance will power off.
B. Temp Decreases Button: Used to lower (cool) the set temperature by 1°C or 1°F. When the screen is
flashing, press it once, the temperature setting is down by 1°C or 1°F, the lowest setting temperature
is 1°C (34°F).
C. Temp increase button: Used to raise (warm) the set temperature by 1°C or 1°F. When the screen is
flashing, press it once, the temperature setting is up by 1°C or 1°F, the highest setting temperature is
8°C (46°F).
D. Color Switch Button:
1. Color can be switch to white or blue by pressing the button for once.
2. Press and hold the button for 3 seconds can switch the temperature display setting in
Fahrenheit or Celsius degree.
3. Lights would on when the drawer has been opened.
E. Mute Button:
1. Mute the alarming voice by press the button once.
2. Mute the pressing voice by press and hold the button for 3 seconds.
F. Lock/Unlock Button: Press and hold for 3 seconds can lock or unlock the appliance. Lock or unlock
will show on the screen. Appliance will lock automatically when the appliance doesn’t have any move
in 1 minute.
2. There is automatic storage memory when power off in this wine cooler, that means the setting
temperature is memories automatically even in power off, so the setting temperature is the same as
last setting when the wine cooler is running again.
3. Defrosting: The unit defrosts automatically. The evaporator behind the rear wall of the unit defrosts
automatically. The condensate collects in the drainage channel behind the rear wall of the unit, and
flows through the drainage hole into the drip tray by the compressor where it evaporates. When the
wine cooler run for some time, the wine cooler will enter to defrosting, the compressor stop running
and the fan will keep running. The temperature will up to about 5°C when defrosting, then keep on
running normally; It takes more time for the temperature to come up to 5°C when the setting
temperature is low (for example the setting temperature is 1°C), and there are full of wines in the
cabinet, and this is not a breakdown.
To Next Page
Loading...
