LEVELING THE UNIT
ELECTRICAL CONNECTION
INSTALLING HANDLE
EXTENSION CORD
LEVELING THE UNIT
ELECTRICAL CONNECTION
INSTALLING HANDLE
EXTENSION CORD
INSTALLATION INSTRUCTIONS
LEVELING THE UNIT
INSTALLING HANDLE
ELECTRICAL CONNECTION
ELECTRICAL CONNECTION
Position the unit ona flat, level surface capable of
supporting the entire weight of the unit when full. This
unit contains four (4) adjustable leveling legs. Turn the
legs clockwise to raise and counterclockwise to lower.
Locate the handle (1) over the pins (3) of the door and
tighten the handle by screwing the Allen key grub screws (2)
!
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by a qualified electrician or an authorized service center.
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied.
For personal safety, this appliance must be properly grounded. Any questions concerning power and/or
grounding should be directed toward a certified electrician or an authorized service center.
This appliance requires a standard 115/120Volt AC-60Hz three-prong grounded electrical outlet. Have
the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or
dangling.
The appliance should always be plugged into its own individual electrical outlet which has a voltage
rating that matches the rating on the appliance. This provides the best performace and also prevents
overloading house wiring circuits that could cause a fire hazard from overheating. Never unplug the
appliance by pulling on the power cord. Always grip the plug firmly and pull straight out from the
receptacle. Repair or replace immediately all power cords that have become frayed or otherwise
damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end. When
moving the appliance, be careful not to damage the power cord.
Because of potential safety hazards under certain conditions, it is strongly recommended that you do
not use an extension cord with this appliance. however, if you must use an extension cord it is absolutely
necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding
type plug and outlet and that the electrical rating of the cord be 115 Volts and at least 1.3 amperes
To Next Page
Loading...
