STARTING:
OPERATION:
4
Choke
(cold engine)
Starter
• Before starting the new post driver, press the
transparent and semi-circle fuel bubble
repeatedly until carburetor is filled with fuel
see (figure 2).
(If the engine is cool, close the air door
—open air door after starting)
• Set the machine upright according to (figure 3). Hold the upper part of the handle tightly
with one hand, while the other pulls the starter grip quickly (remember to extend cord
sufficiently). Do not let the starter grip go back freely in repeated pulling—but hold it
tightly to avoid injury.
• Start the gasoline engine and then open-air door completely. After idle operation of
5 minutes, start normal work operations.
• After the gasoline engine is started, idle engine for 5 minutes to warm up the driver.
• After warmed up, press throttle handle to the appropriate regulatory position, according
to the required impact energy.
(Note: The new gasoline post driver use should mainly be set to low or medium-speed for the
first 20 hours of operation—refrain from using maximum throttle— this will extend the
service life).
• Operating speed of gasoline engine is best at medium speed.
• High-speed operation of post driver during non-piling is prohibited.
Figure 2.
To Next Page
Loading...