Need help?Do you have a question about the THORENS TD 524 and is the answer not in the manual?
Ensure local mains voltage matches unit setting; select voltage using the switch on the underside.
Align cartridge with mounting guide and select appropriate spacers for correct stylus tip height.
Mount cartridge to wand using screws, spacers, and lifting handle assembly for secure attachment.
Select speed via rotary switch; verify accuracy using the stroboscope.
Balance the tone arm by adjusting the counterweight until the stylus hovers at record playing level.
Adjust the tracking force dial based on cartridge recommendations and playback conditions.
Increase tracking force slightly if audible distortion occurs in either channel during playback.
Skating force pulls the arm inward; counteract this with the antiskating force mechanism.
Ensure local mains voltage matches unit setting; select voltage using the switch on the underside.
Align cartridge with mounting guide and select appropriate spacers for correct stylus tip height.
Mount cartridge to wand using screws, spacers, and lifting handle assembly for secure attachment.
Select speed via rotary switch; verify accuracy using the stroboscope.
Balance the tone arm by adjusting the counterweight until the stylus hovers at record playing level.
Adjust the tracking force dial based on cartridge recommendations and playback conditions.
Increase tracking force slightly if audible distortion occurs in either channel during playback.
Skating force pulls the arm inward; counteract this with the antiskating force mechanism.
General| Drive system | Belt drive |
|---|---|
| Platter material | Aluminum |
| Platter diameter | 300 mm |
| Cartridge | Not included |
| Motor type | Synchronous motor |
| Speeds | 33.33, 45 RPM |
| Effective tonearm length | 232 mm |
| Tracking force range | 0-3 g |
| Anti-skating adjustment | Yes |
| Type | Manual turntable |
To Next Page
