Need help?Do you have a question about the THORENS TD 125 and is the answer not in the manual?
Check and adjust output voltages for different speed settings.
Adjust speed potentiometers for correct stroboscope ring standstill.
Lubricate turntable bearing with special oil if necessary.
Synchronous motor bearings require no lubrication.
Replace neon bulb with its plastic housing.
Remove and replace the generator circuit board.
Replace and adjust the microswitch for proper operation.
Clean the stroboscope mirror and lens system.
Remove and clean the front panel components.
Adjust voltage for phase 1 at specified speeds.
Adjust voltage for phase 2 at specified speeds.
Adjust speed potentiometers to standstill stroboscope ring.
Check and adjust output voltages for different speed settings.
Adjust speed potentiometers for correct stroboscope ring standstill.
Lubricate turntable bearing with special oil if necessary.
Synchronous motor bearings require no lubrication.
Replace neon bulb with its plastic housing.
Remove and replace the generator circuit board.
Replace and adjust the microswitch for proper operation.
Clean the stroboscope mirror and lens system.
Remove and clean the front panel components.
Adjust voltage for phase 1 at specified speeds.
Adjust voltage for phase 2 at specified speeds.
Adjust speed potentiometers to standstill stroboscope ring.
General| Drive System | Belt drive |
|---|---|
| Motor | 16-pole, 2-phase synchronous motor |
| Speeds | 16, 33 1/3, 45 rpm |
| Drive method | Belt drive |
| Wow and flutter | 0.06% WRMS |
| Platter | 6.8 lbs (3.1 kg), non-magnetic |
| Tonearm Compatibility | Standard 9-inch tonearms |
| Suspension | Spring suspension |
| Speed control | Electronic |
| Rumble | -68 dB |
| Platter weight | 6.8 lbs (3.1 kg) |
To Next Page
