THORLABS PM103 Operation Manual

1 General Information
Rev: 1.0, 15-Mar-2021
Page 4
1.3 Requirements
Hardware Requirements
PM103: Please provide an appropriate cable to be attached to the DA-15 connector.
PM103A: Please provide appropriate cables to connect to the SMA ports.
Software Requirements
All models of the PM103x can be run with the Thorlabs' OPM software. Please see the require-
ments for the OPM on the website.
Sensor Requirements
Thorlabs C-Series Sensors
The PM103x supports all Thorlabs C-Series photodiode and pyroelectric sensors. The C-Series
can be easily identified by the red connector-housing of the DE-9 connector, compared to older
versions of Thorlabs power sensors.
Please refer to the chapter Connecting a Power Sensor on how to use older Thorlabs
sensors or custom sensors.
6

THORLABS PM103 Specifications

General

Brand	THORLABS
Model	PM103
Category	Recording Equipment
Language	English