15
step 10: install the tipping restraint hardware kit
10.1. Adjust the pre-attached floor levelers to level the unit against a wall.
10.2. Follow the instructions printed on plastic bag containing tipping restraint hardware to attach tip-over restraint between the unit and wall.
NOTE: You must use this tipping restraint to attach this unit to the wall, to prevent accidents and/or injures.
Tools required: Phillips screwdriver, stud finder, tape measure, pencil, power drill and 1/8” drill bit (not provided).
Wooden stud
(H9) x 2
tipping restraint hardware kit
Wall
Metal bracket Nylon strap
Short screw
Wall
Long screw
Floor leveler
H9
To Next Page
Loading...
