ADVANCED FUNCTIONS
3/6
• POWER switch (13):
- OFF position = the gamepad is off (and doesn’t use up batteries).
- ON position = the gamepad is on.
• MOTOR switch (13):
- OFF position = vibration mode is disabled (uses less battery power).
- ON position = vibration mode is enabled (uses more battery power).
• CONNECT buttons (8 and 9)
The connection between the gamepad and the receiver is established automatically.
These 2 buttons allow you to establish a connection in case of failure or when using more than one T-
Pad Wireless gamepad at the same time.
- Both LEDs are on = signal between the gamepad and the receiver.
- Both LEDs flash quickly = no signal between the gamepad and the receiver.
- Both LEDs are off = the gamepad is in standby mode or switched off.
- Both LEDs flash slowly = change batteries.
• STANDBY MODE:
- The gamepad switches off automatically after 5 minutes of inactivity.
- To reactivate it, press the START button.
• TURBO button (7):
This button allows you to repeat an action continuously by keeping another button pressed down
(example: for shooting or hitting functions).
- Simultaneously press the TURBO button and the button corresponding to the action you wish to
repeat.
- Turbo mode is now enabled.
- To disable Turbo mode, repeat this procedure. Turbo mode is now disabled.
• SLOW button (3):
This button allows you to slow down an action by repeatedly activating the START/PAUSE function.
- Press the SLOW button to enable the function.
- Press the SLOW button again to disable the function.
To Next Page
Loading...
