PROGRAMMING BUTTONS / ANALOG MINI-STICKS / D-PAD
All buttons, mini-stick directions and D-pad directions can be programmed.
The MAPPING button (6) allows you to switch the functions of your choice.
• Examples of possible applications:
- Switch the A and B buttons.
- Replace the R and L buttons with the up/down directions on the right mini-stick (for racing games).
- Switch the two analog mini-sticks (in this case, you must map the four directions of the first mini-
stick to the four directions of the second).
- Switch the D-Pad with an analog mini-stick (in this case, you must map the four directions of the D-
Pad to the four directions of the mini-stick in question).
• Programming/switching procedure:
Steps Action
LED (11)
(on gamepad)
1 Press and release the MAPPING button (6) FLASHES SLOWLY
2 Press and release the button or direction to switch FLASHES QUICKLY
3
Press and release the button or direction where you wish to
place the function
ON
The two functions are now switched.
• To return to “default” programming (to erase all of your programming):
Steps Action
LED (11)
(on gamepad)
1 Press and hold the MAPPING button (6) for 2 seconds FLASHES SLOWLY
2 Release the MAPPING button (6) ON
Your programming is now erased.
Please note that your programming also disappears each time the gamepad is disconnected,
or when the gamepad or console restarts.
USING MORE THAN ONE T-WIRELESS GAMEPAD AT THE SAME
TIME
(In multiplayer mode)
You can use up to 4 T-Wireless gamepads at the same time (in multiplayer mode).
To do so, channel detection must absolutely be carried out manually, as described below.
• Procedure:
- For 2 seconds, simultaneously press and hold the 2 CONNECT buttons on the gamepad
and the receiver you wish to use (8 and 9).
- Repeat this procedure for other players.
Once a connection has been established, the LEDs stop flashing and stay lit.
4/6
To Next Page
Loading...
Need help?
General
