ThumbsUp A93TN - Recording a Video; STANDARD RECORDING; SOUND ACTIVATED RECORDING; MANUAL AND AUTO POWER OFF

4
Recording a Video
STANDARD RECORDING
Ensure the Micro SD card has been inserted; if it is missing, the
camera will power o automatically after 30 seconds.
To switch the camera on:• Press the POWER button.
The blue indicator light will glow to indicate startup mode.
To start recording:• Press the Record button.
A solid blue light will illuminate and a red light will ash slowly to indi-
cate recording is in progress,
During recording: • For best results, ensure the main object of
focus remains 50cm from the camera in sucient lighting
To stop recording:• Press the record button again.
The le will be automatically saved. The red light will ash quickly to
indicate ‘le saved’ and then will turn o.
To make further recordings• : Repeat the procedure.
Note: It takes a few moments to save a le after recording. Allow the
procedure to nish before starting a new recording, Pressing the record
button repeatedly may disrupt this procedure.
SOUND ACTIVATED RECORDING
Press the POWER button to turn the DV camera on. •
The blue indicator light will glow to indicate startup mode.
Press the MODE button to change to sound activated mode.•
The blue light will remain on and the red light will ash rapidly to indi-
cate sound acitvated standby mode.
When a sound greater than 60 decibels (60dB) is picked up by the cam-
era, it will begin to record automatically. While lming, the blue light
remains on and the purple light ashes slowly.
When the camera enters sound activated mode it will run for a mini-
mum of 2 minutes. After 2 minutes, if there is no sound, the DV Camera
will save the le automatically and revert to standby mode. If the sound
continues after 2 minutes, the camera will continue to lm.
Any sound louder than 60dB will activate the camersa and another re-
cording cycle will commence.
When recording ensure the microphone is not obscured.
MANUAL AND AUTO POWER OFF
To manually turn the power o: • hold the power button for 3
seconds and then release.
The indicator lights will illuminate then turn o.
Auto-power o function•
When battery power runs low while lming, the le will be 1.
saved automatically before the camera turns o.
When there is not enough space left on the Micro SD while lm-2.
ing, the le will be saved automatically before the camera pow-
ers o.
In standby mode, if no actions are made for 45 seconds, the 3.
camera will auto-power o.