THUNDER TIGER MD530 User Manual

MEMO
JK6014
Specifications:
Fuselage Length (less rotor): 49" (1245mm)
Fueslage Width (less rotor): 18.75"(475mm)
Full Equipped Weight: 7.7 lbs (3500g)
Hughes 530 MD Scale Fiberglass Fuselage (TTR3837)
This kit is guaranteed to be free from defects in material and workmanship at the date of purchase.
It does not cover any damage caused by use or modification. The warranty does not extend
beyond the product itself and is limited only to the original cost of the kit. By the act of building this
user-assembled kit, the user accepts all resulting in liability for damage caused by the final
product. If the buyer is not prepared to accept this liability, it can be returned new and unused to
the place of purchase for a refund.
Warranty
Notice: Adult Supervision Required
This is not a toy. Assembly and flying of this product requires adult supervision.
Read through this book completely and become familiar with the assembly and flight of this MD-
530. Inspect all parts for completeness and damage. Browse www.thundertiger.com for customer
service if you encounter any problems.
1
16
Assembly Manual

THUNDER TIGER MD530 Specifications

General

Brand	THUNDER TIGER
Model	MD530
Category	Toy
Language	English

Summary

MD530 Specifications and Notices

MD530 Specifications

Details key measurements and weight for the Hughes 530 MD Scale Fiberglass Fuselage.

Product Warranty Information

Outlines the guarantee against defects and limitations on warranty coverage.

Adult Supervision Requirement

Mandates adult supervision for assembly and flying, emphasizing safety.

Introduction and Preparation

Introduction to the MD530 Fuselage

Congratulates the user and introduces the MD530 scale helicopter fuselage.

Pre-Assembly Notes and Guidance

Provides essential notes and guidance before beginning the assembly process.

Before Starting Assembly

Offers suggestions for fine-tuning the helicopter and checking kit contents.

Tools, Materials, and Parts

Recommended Tools and Materials

Lists necessary adhesives, tools, and materials for successful model assembly.

Items You May Need

Details specific items like fueler valves and glow adapters for the R/C system.

R/C System and Helicopter Requirements

Specifies the required R/C system and suggests a compatible helicopter model.

Addendum and Parts Drawings

Provides detailed drawings for identifying after-sale spare parts for the military version.

Parts Check List

Lists all kit components, including fuselage parts, retainers, windshields, and screws.

Assembly Steps

Rocket Launcher Assembly

Instructions for trial fitting, preparing, and epoxying the rocket launchers to the fuselage.

Landing Skid and Strut Installation

Guidance on assembling and attaching the landing skid, struts, and braces.

Fuselage and Tail Section Assembly

Details on attaching the tail boom, securing the fuselage, and installing the vertical fin.

Windshield and Wire Strike Installation

Instructions for fitting and securing the front windshield and wire strike.

Final Assembly Details

Covers installing vacuum formed decorations, exhaust vents, and tail skid.

Test Flight Procedures

Hovering and Rotor Speed

Recommends maintaining a specific rotor speed (1600-1700 RPM) during hovering.

Post-Flight Checks

Advises checking for loosened screws after each flight session.

Flight Trimming Adjustments

Suggests trimming elevator down to counter nose-up tendencies in speed flight.