Need help?Do you have a question about the THUNDER TIGER Ready mk3 and is the answer not in the manual?
General| Brand | THUNDER TIGER |
|---|---|
| Model | Ready mk3 |
| Category | Toy |
| Language | English |
Locate spinner, engine prop nut, washer, and propeller. Install backplate with 2mm clearance.
Remove engine and mount, then drill 2.4mm (3/32") holes on marked locations.
Connect throttle pushrod to lever and bend as shown. Insert through firewall.
Install engine, trial move pushrod for smooth operation. Secure engine with mounting screws.
Drill cowl for muffler hole, enlarge to 6mm. Install muffler extension and secure with bolt.
Install propeller and spinner backplate, ensuring alignment with pin for starting angle.
Connect fuel tube correctly to the muffler and carburetor.
Instructions for assembling the main wing structure, including joiners and servo rails.
Attaching the nose cone and firewall to the fuselage structure.
Details on fitting the main and nose landing gear components.
Installation of the fuel tank and routing of control pushrods.
Connecting and assembling the vertical and horizontal tail surfaces.
Setting up the control linkages for ailerons, elevator, and rudder.
Mounting servos and receiver within the fuselage.
Ensuring all parts are secure and controls are functioning.
To Next Page