Er15 is displayed There is most likely a If the cable is damaged it must be
short in the weigh bar replaced. If the problem is in a weigh
or its cable bar, return the complete scale for
service.
‘1 OL’ displayed There is too much weight This error will self clear when the weight
on the bar indicated. removed. This display could flash up for
a fraction of a second if there is a
momentary overload due to a heavy
weight being put down.
Options
The T10 can be supplied with various load cell options. These are:
Easymove 500kg bars- 2 bars, 580mm in length designed for portability.
Easymove 2000kg bars- 2 bars 580mm in length also designed for portability.
Extender 3000kg bars- 2 bars 1000mm in length.
The 3000kg bars are designed to fit under cattle crushes or large weigh bins for
maximum stability.
Specifications
Indicator:
Battery Voltage - 6Vdc (4 x AA batteries)
Supply Current:
Indicator only - 10mA
System with 1 weigh bar- 39mA
System with 2 weigh bars- 68mA
Load Cell Excitation Voltage - 3.3Vdc
Load cell input sensitivity - 1.2-3.2mV/V
Maximum offset voltage:- +/- 20mV
Accuracy - Greater than 99%*
IP Rating - IP56
Weigh Bars:
Gauge resistance - 120 Ohms
Offset Error - Within +/- 10mV
Sensitivity - 1.35 – 2.1mV/V
Overload Capacity - 150% of rated capacity
*Provided installation is done correctly.
E&OE. This information was correct at the time of compilation. Changes may be made to improve the product.
To Next Page
Loading...