Store the indicator in a dry area away from moisture when not in use. Although it
has a gasket seal to prevent water ingress, repeated cycling of warm and cool from day
to night in a damp area may cause a build up of moisture inside the indicator.
Do not transport weigh bars or load cells with a weight on them. If the vehicle
goes over a bump, the resulting ‘G’ forces increase the effective weight applied, which
may exceed the load cell capacity, causing damage to the load cells. Load cells that
have had excessive weight applied to them are not covered by warranty.
Power
The T10 is powered by 4 x AA batteries. These are inserted in a removable battery
pack and placed in the battery compartment at the rear of the indicator.
A battery level indicator is displayed while the scale is operating, which gives an
indication of the time remaining before the batteries go flat. The lowest segment will
start flashing when the battery level is low and the charger is not plugged in. Turn off
the indicator and replace the batteries when this occurs.
Good quality alkaline batteries will power the scale for up to 30 hours running time.
Rechargeable AA batteries may be used, but the battery level indicator will not be as
accurate.
The T10 will turn itself off after 30 minutes if no keys have been pressed or if the weight
has not changed.
To Next Page
Loading...