10
NVA100X - Getting started - 01 - 2018
is impossible to make any modification (keeping pressed for some seconds the key
(Enter) modi-
fication procedure is disabled (LED START, TRIP and curson under the parameters to be modified).
Changing password
After correct insertion of password is displayed this message: ENTER PASSWORD and
PASSWORD OK >>; pressing the key
is shown the message CHANGE PASSWORD
>> and pressing button
you access the relative menu where you can enter the new password
.
Lost password
To change password current one must be entered. If the password is lost, neither the password nor
any parameter from MMI can be changed and the changes can only be made by ThySetter.
To enable modification from MMI without password is needed to disable password lock connecting a
PC with Thysetter setting ON parameter Parameters setting enable available in menu Set / MMI.
If password is lost and password lock must be enabled, device database must be reset using the com-
mand Set default setting available in the menu Command \ Default setting. (double click on Default
Setting, click on Set default setting, right click --> Send Command).
Note:
The command Set default settings restores the factory settings, all user- defined
adjustments are cleared.
Be carefully to enter the correct parameter !
The device serial number should be set to avoid IP address conflicts for devices con-
nected to the Ethernet network.
To Next Page
Loading...
Need help?
General
