Tiandy IP Speed Dome Camera - Page 77

D:Pattern
MOTION
-------------------------------------------
<Preset>
<Scan>
<Cruise>
<Pattern>
<Zones>
<Timing Action>
Back
Exit
PATTERN
-------------------------------------------
Pattern Number ：001
Title Set ：PATTERN 1
Start
<Set>
Delete
Back
Exit
A1
B1
C1
D1
E1
A1. mode path group
Move the cursor to "mode path group number" in Aperture opening into the path group
setting mode, rocker mode path group, setting up or down. Ball machine total supporting
8 pattern path.
B1. Title settings
Move the cursor to the "headings" title by the IRIS on entering mode path settings
submenu, mode path header settings. Note: the current title set is on the WEB.
C1. startup path. Move the cursor to "start mode path" by IRIS on path to initiate a pattern
group number mode path.
D1. set
Move the cursor to "set", in Aperture opening into the set mode, users can operate on the
machine and ball machine will record user actions, users press the aperture on the key
end mode path is set, at the same time if the progress bar when the expiration time or
record to (dome records of maximum support for 180 seconds), the mode and path
settings will automatically end.
E1. Delete
Move the cursor to "delete", by IRIS on path group deletes the corresponding mode
number mode path.