Tibo Plus 1.1 - User Manual

Questions and Answers

M
marisapollardAug 11, 2025
What to do if there is no playback via Bluetooth on my Tibo Plus 1.1 Speakers?
- C
  connorjohnsonAug 11, 2025
  If there's no Bluetooth playback on your Tibo Speakers, first connect your Bluetooth device as described in its user manual. If already paired but still no playback, reconnect the Bluetooth device. Ensure you're within range, the volume on both your device and the speakers are at maximum, and there are no interference sources nearby, such as a WLAN router or laptop. If you are still experiencing issues, disable WLAN on your mobile device, as concurrent operation of WLAN and Bluetooth can cause interference.
B
brycebushAug 19, 2025
Why doesn't the remote control for my Tibo Plus 1.1 function?
- E
  ekennedyAug 19, 2025
  If the Tibo Speakers remote control isn't working, try these steps: * Install two new AAA batteries. * Make sure that you point the remote control directly at the remote sensor on the speakers. * Ensure you are within the remote control's operating range. * Switch the unit off, disconnect it from the AC outlet, and then power it back on.
R
Robert ForbesSep 3, 2025
Why do my Tibo Plus 1.1 have no power?
- S
  stephensmeghanSep 3, 2025
  If your Tibo speakers have no power, please check that the AC power cord is connected correctly to the power supply.
S
Stephanie LewisNov 25, 2025
How to fix humming sound from Tibo Plus Speakers?
- A
  Angela MacdonaldNov 25, 2025
  If your Tibo Plus speakers are humming, it could be due to several reasons. The signal lines from the source device might be too long or not properly shielded. A ground loop could also be the cause, especially if multiple devices are connected via a signal line and plugged into separate sockets. Another device on the same circuit might also be causing interference. To resolve this: * Use a shorter, fault-protected signal line. * Plug all devices connected to the Plus speakers into a multiple socket output using safety plugs. * Switch off potential sources of interference or connect them to a different circuit. * Consider using a ferrite common mode filter between the amplifier and the Plus speakers. * Turn the power plug around to reduce ripple voltage, especially if the source ...