Tidal Engineering Synergy Quattro - Page 2

Synergy Controller Technical Manual, Revision H
Page 2
Revision History
Rev.
Date
Revision
C
June 16,2005
First Release
D5
June 27, 2006
Added revision page
Updated chapter numbering for sections 8.1.1, 9.7, 11.4
E
October 17, 2006
Updated for Synergy Controller application version 2.0.8.
Added for Synergy Micro 2 Controller configuration.
Updated Overlay and Web Touch Graphics.
Revised Software Upgrade instructions in section 7.
Added LCD Backlight CCFT Lamp Replacement instructions in section 7.
Updated command set Appendix C to 2.0.8 and added examples.
Add section on Macro capability and Bar Code Scanner application.
Added replacement parts list, Section 20 Appendix C.
General document review and edit.
Corrected error in “Analog Retransmit Connections Table”
Revised Output Mapping tables in section 6.10
Revised Synergy Controller Compact Interface Panel Layout figures
F
January 10, 2008
Updated for Synergy Controller application version 2.6.10.
Added UUT Module Mechanical Drawing
Added new section for User Programmable Alarm System.
Added 4-20 mA sensor wiring section.
Added Space and Altitude section
Added Altitude section in L Values for Altitude and Space Chamber Configuration.
Added LabVIEW driver section.
Added Deviation Alarm feature.
Added PID tuning guidelines
Added touch screen calibration for Micro unit
Simplified Olympic board schematic
Added Block Diagram
Added High and Low Res Event Screens
Added Input Calibration section
Added Retro Temperature Only Configuration
Add Safety section
Added USB Bar Code reader setup for Micro applications
Added Installation Section
Added bookmark hyperlinks to document
G
October 5, 2015
Updated for Synergy Controller application software version 3.0.7 Build 893.
Upgraded figures to show Synergy Micro 2 configuration.
Reorganized into 22 sections including 6 Appendices.
Added new section for e-mail features.
Added new section for network printing features.
Updated Space and Altitude section
Added Alarm feature enhancements.
Added touch screen calibration for Micro 2 unit
Simplified Olympic board schematic
Replaced CCFT Lamp replacement with LED upgrade procedure.
H
October 18, 2016
Unified Technical Manual Covers Synergy Controller Software and programming for all
three models: Synergy Micro 2, Synergy Quattro, Synergy Nano