Instrument and function introduction
1.Buttons
There are two buttons on the display panel, namely power button / boot
button and function button / mode mutton
2.Use
Long press to turn on the power, the battery power and speed are
displayed instantaneously according to the running status of the scooter, and the single
mileage and cumulative mileage in the display are displayed according to the selected
function.
After the display panel is turned on, if there is no signal input for a long time (3
minutes), the panel will automatically turn off the power; when the panel shows CA
2:00, it means that it enters the countdown state, and will shutdown after 2hours.
Short press the function button to change the display content. The characters
TIME, TRIP, ODO, DST, VOL, CH 2:00 and so on appear respectively. When
appeared TIME, it means time, when appeared TRIP, it means single mileage, when
appeared ODO, it means accumulated mileage, when appeared DST, it means
remaining mileage (the electric scooter can still run range is based on the current
To Next Page
Loading...
