battery remaining capacity and the running status of the electric scooter in the last few
minutes). When VOL is appeared, it indicates the battery voltage; when CH 2:00 is
appeared, it indicates that it has entered a 2-hour shutdown countdown state (some
models do not have this). As time passes, the time display decreases.
Long press function button, clearance the single mileage (under TRIP content).
Short press power button, the gear number will flash, then press mode
button will change the gear, 1 is slow speed, 2 is medium speed, 3 is faster speed
gears. When the panel is turned on, long press power button to turn off the
power.
3.Parameter setting
When function button and power button at the same time, the panel
parameter setting state is entered:
When P0 is displayed, short press the function button again, P1 will be
displayed, and then short press function key, P2, P3, P4, P5, P6, P7 will be
displayed in turn; And they respectively indicated :
P01:brightness level of background
P02:0：KM；1：MILE； ODO unit KM 1 :mild
P03: Ｖｏｌｔａｇｅｌｅｖｅｌ：４８Ｖ，６０Ｖ Ｔｈｅｄｅｆａｕｌｔ：６０Ｖ
P04：Dormancy time :0, Non-dormancy ; the other data is dormancy time,
range : 1-60 minutes;
P05: it’s forbidden ,gear 1~3 to choose
P06:wheel diameter unit : inch, accuracy :0.1
P07:speed testing of magnetic cylinder quantity
P08:it’s forbidden, most of controller do not support it .
P09:Zear start、non-Zero start setting , 0 : zero start ;1 Non-zero start
P10：setting way of driving 0 assistant driving , 1 motor driving 2
To Next Page
Loading...
