5）How to start
Step1. Press the POWER button on the display for 3 seconds to turn on the display.
* The power of the display will turn off automatically after a few minutes of inactivity. At this time,
the LED lamp is also turned off, so turn it off with the LED lamp button before you turn it on again.
Step2. Stance for driving
After tilting the kickstand, find a stable position on the footrest and then hold the handle
grip comfortably. Be careful not to raise your foot on the rear fender.
* Scooter are regularly with “zero start” when out of factory, users need to kick ground to start
ride
.
Step3. Acceleration
Acceleration can be performed by using the throttle of the display while driving, and the
deceleration or stop can be performed by holding the brakes on the handle.
Caution !
Before driving,be sure to check the folding part, the handle part and the part where the
main fixing part of the product are fastened well. And check the position of folding part
fixing status.
Throttle malfunction caution
Regardless of whether the throttle is operated or not, the motor sensor may continue to
operate,causing malfunctions such as sudden acceleration. In this case, holding the
brake lever to cancel the operation. This phenomenon may be caused by corrosion of
the throttle,immersion of the throttle,disconnection of the magnet, broken off
levers,and broken spring. Do not bounce the throttle lever strongly.
6) How to stop
Attention to using the brake gently first,don't brake suddenly.When you brake
gently,the ABS function started. This will be very effective in reducing speed. After the
To Next Page
Loading...
General