iii
Table of Contents
1 Contact Us
2 Parts Inventory
9 SawGear Installation
9 ElEctrical rEquirEmEnts
9 sawGEar BEnch mount BrackEts
11 connEctinG thE Flip-away stop
11 attachinG thE stop Bar
12 connEctinG thE powEr hEad
13 SawGear Operation
13 sawGEar control panEl
14 sawGEar lcd display
14 1st powEr-on
15 rEpEat a 1st powEr-on
15 normal powEr-on
16 start sawGEar
16 slEEp modE
16 sEt contrast
17 password protEction
17 chanGE thE password
18 dEactivatE thE password
18 incrEmEnt
19 lists
20 EntErinG FEEt, inchEs, and Fractions
21 EntErinG FEEt and dEcimal inchEs
21 EntErinG non-standard Fractions
21 EntErinG millimEtErs
22 EntErinG nEGativE numBErs
22 caliBration
24 straiGht cuttinG
24 45° mitEr cuttinG
25 custom mitEr cuttinG
26 Pivot Point Calibration
26 mitEr saw accuracy
28 Crown + Miter Pro
28 GEttinG startEd
28 how to usE crown & mitEr pro
31 Troubleshooting
31 corrEctinG Entry Errors
31 “too BiG” Error
31 “too small” Error
32 homE routinE aFtEr impact
32 scalinG instructions
33 Appendix A: Power Head
Controller Stand
34 Appendix B: Panel Saw
Retrofit
34 univErsal BrackEt installation
34 BEnch mount BrackEt installation
35 sawGEar mountinG
35 assEmBlE support lEG
36 attach support lEG
37 connEctinG thE powEr hEad
37 connEct caBlE Guard to powEr hEad
38 connEctinG thE Flip-away stop
38 attachinG thE stop Bar
39 attach controllEr to saw
To Next Page
Loading...
