EasyManuals Logo

TILLOTSON TPP-212E User Manual

TILLOTSON TPP-212E
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
Before performing adjustments or repairs:
Disconnect the spark plug wire and keep it away from the spark plug.
Use only correct tools.
Do not tamper with the governor spring, links or other parts to increase engine speed.
Replacement parts must be the same and installed in the same position as the original parts.
Do not strike the flywheel with a hammer or hard object. Doing so may damage or weaken
the flywheel and may cause it to later shatter during operation.
When testing for spark:
Use approved spark plug tester.
Do not choke for spark with spark plug removed.
Maintenance Chart
Carburetor Adjustment
Never make adjustments to the carburetor. The carburetor was set at the factory to operate efficiently
under most conditions. However, if adjustments are required, see any our Authorized Dealer for service.
In particular, if operating above 2,000 feet altitude, the carburetor may need to be adjusted and should
only be done at an Authorized Dealer
CAUTION: The manufacturer of the equipment on which this engine is installed may specify the top
speed at which the engine will be operated. Do not exceed the manufacturer’s recommended speed.
First 5 Hours
Change Oil
Every 8 Hours or Annually
Check engine oil level
Check muffler and muffler guard and spark arrester (if applicable)
Every 50 Hours or Annually
Change engine oil
Check muffler and muffler guard and spark arrester (if applicable)
Annually
Replace spark plug
Check valve clearance

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TILLOTSON TPP-212E and is the answer not in the manual?

TILLOTSON TPP-212E Specifications

General IconGeneral
BrandTILLOTSON
ModelTPP-212E
CategoryEngine
LanguageEnglish

Related product manuals