www.timberk.com • Electric drier for changing of air humidity
8
2. Continuous draining
Water can be automatically emptied into a floor drain by attaching the unit
with a water hose (not included).
• Cut the cover down from the back drain hose outlet. Attach a drain
hose(ID=13.5mm) and lead it to the floor drain or a suitable drainage
facility(see Fig.7).
• Make sure the hose is secure so there are no leaks.
• Direct the hose toward the drain,making sure that there are no kinks that
will stop the warter flowing.
• Place the end of the hose into the drain and make sure the end of the
hose is level or down to let the water flow smoothly.Do never let it up.
• Select the desired humidity setting and fan speed on the unit for
continuous draining to start.
NOTE:
When the continuous drain feature is not being used,
remove the drain hose from the outlet and attach the
rubber plug back to the drain outlet.
Fig. 7
NOTE:
• When you remove the bucket, do not touch any parts
inside of the unit. Doing so may damage the product.
• Be sure to push the bucket gently all the way into the
unit. Banging the bucket against anything or failing to
push it in securely may cause the unit not to operate.
• When you remove the bucket,if there is some water in
the unit you must dry it .
7. MAINTENANCE
Removing the collected water
There are two ways to remove collected water.
1. Use the bucket
• When the unit is off,if the bucket is full, the Full indicator light will light.
• When the unit is on,if the bucket is full, the compressor and the fan turn
off, and the Full indicator light will light, the digital display shows P2.
• Slowly pull out the bucket. Grip the left and right handles securely, and
carefully pull out straight so water does not spill. Do not put the bucket
on the floor because the bottom of the bucket is uneven. Otherwise the
bucket will fall and cause the water to spill.
• Throw away the water and replace the bucket. The bucket must be in
right place and securely seated for the dehumidifier to operate.
• The machine will re-start when the bucket is restored in its correct position.
Fig. 6
To Next Page
Loading...
Need help?
General