IM2022
54
Maintenance of the Hob
If you find something goes wrong for your hob, before contact the service
or where you purchased it, please check whether below:
1. There is no power to the appliance:
- Check whether there is a power cut of your department;
- Check whether the appliance be connected to electricity properly;
- Has the timer setting elapsed;
- Whether it reaches the longest cooking time setting and auto shut off;
- Whether there is liquid boiling over touch control panel and overflow protection devices auto
shut off;
2. The touch control panel buttons can’t be active:
- Whether it’s under “Child Lock”, which there is “Lo” shows in timer displayer;
- Whether liquid/wet cloth over touch control panel active overflow protection;
3. After cooking there is “H” shows on display:
- This is normal. The hob is with Residual Heat Warning safety features. It will remain on until the
surface is cool enough for touch.
4. The glass is being scratched:
-Check whether you use unsuitable cookware, like rough-edged cookware.
-Check whether unsuitable, abrasive scourer or cleaning products being used.
5. The heating element of ceramic hob turns on and off alternately when working:
-This is normal and natural feature for ceramic hob. Programmer of ceramic hob, together with
the thermostat or thermocouple in heating element, could control the hob work at set power level
and avoid overheat by heating element work on/off alternately.
-If working at highest power level, heating element will continue turn on for a certain time then
on/off alternately.
-If working at other lower power level, heating element will on/off alternately at certain frequency
since beginning based on power setting of the cooking zone.
12. UTILIZATION RULES
The symbol on the unit, packing materials and/or documentations means used electrical
and electronic units should not be toss in the garbage with ordinary household garbage. These
units should be pass to special receiving point.
For additional information about actual system of the garbage collection, address to the local
authority.
Valid utilization will help to save valuable resources and avoid negative work on the public health
and environment which happens with incorrect using garbage.
After the lifetime of the device expires, it should be recycled in compliance with the laws, rules
and methods in region of recycling. Detailed information about the recycling of the device, you
can receive from a representative of the local authorities, after providing full information about
the device.
To Next Page
Loading...