90
Installing In-Deck Light
1
2
3
4
5
Locate and mark the centerline of the deck plank where the
in-deck light will be mounted.
On the desired point of the center line, use a 1” spade bit to
create a through hole (be sure not to drill into the substructure.)
Guide the light’s wire into the through hole.
Push the lighting fixture into the through hole until the flange
touches the deck surface.
The wire connections can then be made under the deck’s
surface.
In-deck light should be installed in a low foot-traffic area.
In-deck light can only be used when there is room under the deck to access the wires to make all of the connections
To Next Page
Loading...