Environmental Manufacturing LLP, Entec House, Tomo Industrial Estate, Stowmarket, Suffolk IP14 5AY
Telephone: 01449 765800 Fax: 01449 765801 Email: info@timberwolf-uk.com www.timberwolf-uk.com
Clearing Blockages…
1. Stop the engine and remove ignition key. Wait for engine to run down.
2. Remove discharge tube by unscrewing clamp with fitted handle only. Check and clear if
necessary.
3. Wearing gloves, reach into the rotor housing and scoop out the majority of any debris
causing the blockage. WARNING… never reach into the rotor housing with unprotected
hands. There are sharp blades inside, and any small movement of the rotor can cause
serious injury.
4. Replace discharge tube.
5. Restart engine and increase to full throttle.
6. Allow sufficient time for machine to clear excess chips before commencing work.
Never attempt to carry on chipping once a blockage is identified. Carrying on chipping in
this instance will compact chips in the rotor housing and will become very difficult to
clear.
The machine must be returned in a clean condition. Cleaning is chargeable at the hire outlet.
Any damage to the machine is chargeable.
timberwolf-uk.com
Dealer Stamp
To Previous Page
Loading...
