10. Random Delay of Programme Start and Finish
Programmes can be started and stopped at random delay times from those programmed
giving the appearance that the lights or other appliances are not being controlled by a
time switch.
To do this press the “Prog” and “Time’ buttons simultaneously when in operating
mode. The RND symbol will appear on the right hand side of the display and will flash
when the random delay period (between 2 and 32 min) is under way.
11. Operating the Controller
Plug the unit into a 13 amp socket and plug the appliance into the time controller and turn
the appliance ON. When socket is switched ON (if necessary) the time controller will control
the appliance. NOTE: The output ON indicator above the display will light up each time an
ON programme is operational.
12. Uses
This timeswitch can be used to control domestic appliances such as heaters rated up to 13A
(3KW), also tumble dryers, washing machines and dishwashers (except those requiring a
permanent supply and which have a push button start).
Lighting which uses incadescent filament lamps rated up to a total of 400W or which uses
up to a total of 100W of fluorescent tubes or low energy lamps can be controlled.
Helpline
If you are experiencing problems in operating your time controller, please ring our Helpline
on 020 8450 0515.
Specifications
Switch Rating: 13 amp (3kW) resistive, 4 amp inductive,
400W filament lamps
Switch Voltage: 230V AC 50Hz
Operating Temp: 0°C to 40°C
Battery: Factory fitted rechargeable. Provides up to 100 hours of
clock operation and memory back-up.
EC Directives: Conforms to 73/23/EEC and 89/336/EEC
Not suitable for discharge lighting.
Can be used with up to 100W of linear tube fluorescent or low
energy lighting.
6
To Next Page
Loading...
