_______________________________________________________________________________
CANline "n" Default: $18 <CTRL-X>
Mode: All Host: CL
_________________________________ Parameters: _________________________________
"n" - 0 to $7F (0 to 127 decimal) specifies an ASCII character code.
_______________________________________________________________________________
The parameter "n" is the ASCII code for the character you want to use to cancel
an input line. You can enter the code in either hex or decimal.
When you use the CANLINE character to cancel an input line in Command Mode, the
line is terminated with a <BACKSLASH> character and a new prompt (cmd:) appears.
When you cancel lines in Converse Mode, only a <BACKSLASH> and a new line appear.
o You can cancel only the line you are currently typing.
o Once <CR> or <Enter> has been typed, you cannot cancel an input line.
NOTE: If your send-packet character is not <CR> or <Enter>, the cancel-line
character cancels only the last line of a multi-line packet.
_______________________________________________________________________________
CANPac "n" Default: $19 <CTRL-Y>
Mode: Packet, Command Host: CP
_________________________________ Parameters: _________________________________
"n" - 0 to $7F (0 to 127 decimal) specifies an ASCII character code.
_______________________________________________________________________________
The parameter "n" is the ASCII code for the character you want to type in order
to cancel an input packet or to cancel display output from the PK-232.
You can only cancel the packet that is being entered in CONVERSE Mode. When you
cancel a packet, the line is terminated with a <BACKSLASH> and a new line. You
must cancel the packet before typing the send-packet character.
In the COMMAND mode, this character cancels displayed output from the PK-232.
Typing this character once cancels ALL output from the PK-232 to your display.
Typing the cancel-output character again restores normal output.
_______________________________________________________________________________
CASedisp "n" Default: 0 (as is)
Mode: Packet Host: CX
_________________________________ Parameters: _________________________________
"n" - 0 to 2 specifies how your PK-232 sends characters to your terminal.
_______________________________________________________________________________
CASEDISP allows you to set the case of the characters your PK-232 sends to your
terminal. CASEDISP offers three possible modes:
CASEDISP 0 "As is" - characters are not changed.
CASEDISP 1 "lower" - all characters are displayed in lower case only.
CASEDISP 2 "UPPER" - all characters are displayed in upper case only.
CASEDISP has no effect on your transmitted data.
8/91 A-22
To Next Page
Loading...
