Timex T433 User Manual

Battery Back-Up System
This dock radio is equipped with a back up system that is
powered by two customer-installed "AA" alkaline batteries
(not included). The backup circuit will not operate unless
batteries are installed.
When normal household current is interrupted, or the AC
line cord is unplugged, the batteries power the clock to
keep track of time, alarm and calendar settings. Should
wake-up time occur during the power interruption, the
alarm will sound for 2 minutes, if remaining battery power
is adequate. If Snooze is pressed during the 2-minute
alarm time period, the alarm will go off and come on again
in approximately 9 minutes. Normal operation will resume
after AC power is restored so you will not have to reset
time, alarm or calendar settings.
Note: The display will remain lit' during battery back-up
when batteries are fresh. The display will gradually fade as
the batteries weaken.
Install batteries as follows:
1. O pen the battery compartment door located on the
bottom of the radio.
5
Wake Switch
Band Switch
Tuning Control
Volume Control
Time Button
Alarm Button
Reset Button
• | Sleep Button
Calendar Button
LCD Display
< (Slow Reverse) Date - Button
« (Fast Reverse) Date + Button
2. Insert 2 “'AA" alkaline batteries making sure the polarity
is correct as shown in the compartment.
Note: Alkaline batteries are recommended for longer life.
3. Close the compartment door.
Important: Remove batteries when storing the clock
radio. The batteries will be drained if left connected when
the unit is unplugged, and worn out batteries may leak
chemicals which can badly damage the clock radio.
Dispose of batteries in the proper manner, according to
your state and local regulations.
6
» (Fast Forward) Month Button
LED Dial Pointer

Timex T433 Specifications

General

Brand	Timex
Model	T433
Category	Clock Radio
Language	English