Timotion JP4 - Two Limit Switches to Cut the Current (Without Signal Output)

User Manual-JP4
Version C May 2020
12 of 20
12
2.3.2 Two limit switches to cut the current (without signal output)
The actuator is equipped with two limit switches to cut the current of the motor when the actuator moves to
the end of each stroke and without any output signal.
Wire
AWG
Description
Spec
Yellow
20
Connect to Vm+ to extend the actuator.
Connect to Vm- to retract the actuator.
24V version: Input voltage 18~32 V DC.
12V version: Input voltage 9~16 V DC.
Green
20
Connect to Vm- to extend the actuator.
Connect to Vm+ to retract the actuator.
Yellow
Green