TIMPANO TPT-SP4BT - Introduction; Before Installing

2
Introduction
Thank you for choosing a TIMPANO product!
The TPT-SP4BT is a digital audio processor that oers a variety of high-
precision adjustments and sengs to enhance the performance of
your audio system. Through Bluetooth communicaon, the processor’s
informaon can be viewed and congured remotely using smartphones
with Android or iOS systems. Its digital signal processor (DSP) allows
real-me modicaon of equalizaons, crossover lters, alignment,
gain control, phase inversion, limiter, digital input/output roung, and
other treatments. Its exclusive sequencer feature (SEQUENCER) makes
it possible to congure the programmed startup and shutdown of up to
three products from the remote startup connecons (S1, S2, and S3).
Before installing
Please read this manual carefully.
▪ All connecons must be made with the product turned OFF.
▪ A fuse must be installed between the amplier and the baery is
required to protect against overcurrent. The fuse needs to be installed
as close to the baery as possible. Choose an appropriate fuse for the
amplier based on its consumpon.
▪ Use the wire recommended in this manual to keep cables from
overheang cables and to obtain maximum power.
▪ Keep the cables as short as possible to increase sound delity and
avoid potenal power losses.
▪ Route the installaon cables as far away as possible from the
original vehicle wiring to prevent interference and noise in your
audio system.