EN
10
3. 2-in-1 dusting brush
Switches between a wide and a soft brush by
pressing the release button. The soft brush is
most effective on hard-surface furniture while
the wide brush is effective for upholstered
furniture, curtains, etc.
4. Crevice tool
For corners, nooks, and other hard-to-reach
places such as around car seats, picture frames,
and cupboards.
5. Soft dusting brush
Angled bristles on a slender, oval-shaped rim
provide anti-static, cushioned contact. Suitable
for dusting shelves, lighting, delicate surfaces,
electronics and more.
6. Flexible long crevice tool
Easy to bend, easy to reach tight spots.
Suitable for cleaning dust behind and beneath
furniture, around refrigerators, and many other
tight gaps.
7. Full-size LED soft-roller power
brush
Perfect for hard oors, especially sensitive
wood oor. Picks up coarse and ne dirt at the
same time.
8. Multi-angle folding tube
An articulated joint makes it adjustable to allow
for exibility when cleaning from high to low.
9. Flexible extension hose
Excellent extension and exibility to access
hard-to-reach spaces; perfect for in-care use.
Compatible with all non-motorized Tineco
accessories.
10. Pre-lter cleaning tool
A dirty lter is a leading cause of suction loss,
and this tool is designed to make your lter
last much longer. Place the dirty lter inside the
pre-lter cleaning tool and close the lid. Run
the appliance in MAX mode, and rotate the
side cover.
Fig.B
ASSEMBLY
Tube Installation
• Insert tube.
Fig.C-1
• Press the release button to remove the tube.
Fig.C-2
Brush Installation
• Insert the power brush.
Fig.C-3
• Press the release button to remove the power
brush.
Fig.C-4
Dustbin Installation
• To clean the dustbin more thoroughly, press
the dustbin release button to detach from the
appliance.
Fig.C-5
• When re-attaching the dustbin, hold on an
angle and slot the top of the dustbin into the
hook on the main body. Push upwards until the
hook is xed into the slot on the dustbin and
then it clicks back into place.
Fig.C-6
Battery Installation
• Press the battery release button, and remove
the battery.
Fig.C-7
• To replace, slide the battery into the slot at the
base of the main body. The battery will click
into position when correctly tted.
Fig.C-8
Wall-mounted Dock Installation
1.Install the accessory bracket to the rail of the
wall-mounted dock and push the clip into the
slot to complete the assembly.
2.Stuck the power cord onto the slot behind the
wall-mounted dock. Start from the plug end
and reserve about 5.9” (15cm) power cord to
ensure that the plug can reach the charging
outlet.
To Next Page
Loading...
Need help?
General
