Titan Dynamics
Titan Dynamics Webpage
Visit our Facebook page
Join our Discord server
Page 17 of 25
Section 6: Final Setup & Tuning Tips
• Titan Dynamics strongly recommends the use of Arduplane for all our models.
• Give all control surfaces +- 35 degrees or more throw. The Comet has extremely
effective flaperons, and should be configured as such in Ardupilot.
• Setup motor rotation such that props rotate inwards towards the fuselage for
added torque roll during differential yaw.
• Take-off does not require flaps, but landing can be done easier with half flaps.
• CG is marked under the wing, however, is very forgiving +/- 10mm.
• Add duct tape or other abrasion resistant material to bottom of the fuselage to
increase durability if landing on rough surfaces.
To Next Page
Loading...
