-7
INTRODUCTION
Your Chain Saw
is
precision
built
and
specifically
engineered. It has been carefully inspected through-
out
all
phases of its production and assembled by
men who are well trained in the production of fine
air -cooled gasoline engines and equipment. Your
Chain Saw
is
the finest that money can buy.
We
suggest for continued successful operation of
your Chain Saw that
all
service and major repair
be handled through an authorized Dealer who
is
ex-
'7
perienced in servicing the equipment and has the
-2
necessary parts on hand to give you prompt and
efficient service.
IMPORTANT INSTRUCTIONS
SAFETY AND FIRE PRECAUTIONS
Tighten loose nuts and screws.
Do not start the engine in closed room, make sure
there
is
ample ventilation.
Do not touch chain when engine
is
running, even at
idle speed.
Keep engine adjusted to an idle speed, which stops
chain completely.
Always stop engine when moving from one location
to another.
During break-in period
(5
hours) never
run
engine
at top throttle unless under load.
Do not allow machine to run while it
is
resting on
concrete floor.
Make sure the fan screen
is
clean.
Check fuel and oil line connection for leaks.
Check
air
filter.
If
necessary, clean by rinsing in
pure gasoline.
Check chain.
NOTE
Do not use compressed air to remove
eaw-
dust from the outside of the carburetor.
Be
sure that cutting chain and guide bar are re-
ceiving sufficient lubrication. Check cutting
chain for worn or loose rivets.
A dull or improperly filed chain will cause the saw
Chain Saws, as shipped from the factory, are
pre-
to buck and jump.
cision-sharpened and ready for general purpose
cut-
ting. When you sharpen the chain, keep the same
After refueling move machine a few feet to another
shape of the cutting edge.
-
r
location before starting engine again (Fire Precau-
tion).
TO OBTAIN THE GREATEST EFFICIENCY FROM
Keep saw clean of sawdust and inflammable material.
THE CHAIN YOU MUST:
--I
*I:
Keep spark plugs and wire connections tight,
1.
Keep the same cutting angle on
all
teeth.
PREVENTIVE MAINTENANCE
."-,
2.
Use the right size file or grinding stone.
3.
Keep the side cutting edge vertical.
Remove sawdust and dirt daily so that a thorough
4.
Shape in the top cutting edge correctly.
inspection of the chain saw can
be
made.
5.
Keep
all
depth gauge clearances the same.
WARRANTY
ALL CHAIN SAWS ARE GUARANTEED TO BE FREE
FROM DEFECTS IN
WORKMANSHIP AND MATERIAL AND
WILL WITHOUT CHARGE BE REPAIRED
OR
REPLACED
WHEN, UPON
1NSPECTION AT OUR FACTORY, THEYARE
FOUND DEFECTIVE. THlS GUARANTEE TO COVER
MERCHANDISE WITHIN
30
DAYS FROM DATE OF PUR-
CHASE.
THlS GUARANTEE DOES NOT OBLIGATE US WHERE
EQUIPMENT HAS BEEN DAMAGED BY CARELESS HAND-
LING
OR
BY IMPROPER APPLICATION OR INSTALLA-
TION. NO LIABILITY FOR CONSEQUENTIAL DAMAGES
OF ANY
KIND ARE ASSUMED BY THE COMPANY. THE
PURCHASER BY ACCEPTANCE OF THlS EQUIPMENT,
ASSUMES ALL LIABILITY FOR CONSEQUENCES OF ITS
USE AND MISUSES BY PURCHASER, HIS EMPLOYEES
OR OTHERS.
To Next Page
Loading...
Need help?
General
