Why won't my Titan T9000 start?
If your Titan Vacuum Cleaner won't start, first, ensure it's properly plugged into the wall outlet and the power switch is set to 'ON'. Also, check your household service panel for tripped circuit breakers or blown fuses and reset or replace them if necessary.
How to improve dirt pick-up on my Titan T9000?
If your Titan Vacuum Cleaner isn't picking up dirt well, the dust bag might be full or clogged, so you should change the bag. Another cause might be a hole in the hose, in which case you should replace the hose. It's also possible that the nozzle agitator is worn and needs to be changed. Finally, check if the overload protector in the motorized nozzle has tripped. If so, remove any obstructions and reset it.
What to do if the motorized nozzle on my Titan T9000 Vacuum Cleaner won't run?
If the motorized nozzle on your Titan Vacuum Cleaner isn't running, ensure the nozzle connections are securely plugged in. Also, check if the overload protector in the motorized nozzle has tripped, and if so, remove any obstructions and reset it. Finally, make sure the switch is in the 'CARPET' position.
Why does the 'CHECK BAG' indicator activate on my Titan Vacuum Cleaner?
The 'CHECK BAG' indicator on your Titan Vacuum Cleaner activates because the dust bag is full or clogged, so replace the bag. When using certain attachment tools, this can also happen, but it is normal, and the light should turn off when the tool is removed.
Why does my Titan T9000 start but then shut off?
If your Titan Vacuum Cleaner starts but then shuts off, check the hose or hood electrical connections and reconnect the hose ends.
How to stop my Titan T9000 Vacuum Cleaner from picking up rugs?
If your Titan Vacuum Cleaner is picking up moveable rugs or the nozzle pushes too hard, the pile height setting might be incorrect, so adjust the setting. Alternatively, the suction might be too strong, so select a lower Power Level.
How to fix a Titan T9000 cord that won't rewind?
If the cord on your Titan Vacuum Cleaner won’t rewind, try cleaning the power cord. If that doesn't work, the cord might be jammed, so pull it out and rewind it.
Step-by-step guide to powering on and beginning vacuum operation.
How to reset the belt protection mechanism in the motorized nozzle.
Explanation of the motor's thermal overload protection system.
General| Category | Vacuum Cleaner |
|---|---|
| Type | Upright |
| Cord Length | 8m |
| Filter Type | HEPA |
| Model | T9000 |
To Next Page
