14
TTB517STP by TITAN
In more detail…
GB
Product functions
Firmly press nailer head (4) against the workpiece until there is no gap
between the nailer head (4) and the workpiece.
Briefly press trigger (7) and then release again.
Trigger (7) is locked as long as you do not press nailer head (4) against the
workpiece, thus preventing accidental operation.
At 20 shots/min,tacker should be allowed to cool down after 30 minutes as
it is only rated for short-time duty.
>
>
>
NOTE: remove all staples/nails from the magazine
after each use.
IE
Fig. 5
Operating the tool
>
4
NOTE: when using a nailer/stapler it is best practice
to have one hand on the rear of the tool, opposite
the nailer head. This insures full penetration of the
longer nails/staples whilst keeping your hand away
from the nailer head.
To Next Page
Loading...
Need help?
General
