TTI932CHN
11
Getting
started...
EN
this product.
16.
Only use replacement guide bars and saw chains
specied by the manufacturer or equivalent
replacements. Using non-approved cutting
attachments can result in personal injuries and
damage to property.
17.
Before using the product and after any impact or
dropping, check for signs of wear or damage and
repair as necessary.
18.
Never remove or modify any guard or safety
component. Ensure that guards and other safety
components necessary for machine operation are
in position, in good working condition and properly
maintained to avoid injuries.
19.
Training of all operation is necessary for rst-time
and inexperienced operator.
20.
Remove branches in section.
Causes and operator prevention of kickback
Kickback may occur when the nose or tip of the guide
bar touches an object, or when the wood closes in and
pinches the saw chain in the cut.
Tip contact in some cases may cause a sudden reverse
reaction, kicking the guide bar up and back towards the
operator.
Pinching the saw chain along the top of the guide
bar may push the guide bar rapidly back towards the
operator.
Either of these reactions may cause you to lose control
of the saw which could result in serious personal injury.
Do not rely exclusively upon the safety devices built into
Safety information
To Next Page
Loading...
