48
In
more
detail...
EN
TTI932CHN
Troubleshooting
Suspected malfunctions are often due to causes that the users can x
themselves. Therefore check the product using this section. In most cases the
problem can be solved quickly.
WARNING!
Only perform the steps described within these
instructions! All further inspection, maintenance and repair work
must be performed by an authorised service centre or a similarly
qualied specialist if you cannot solve the problem yourself!
Problem Possible cause Solution
1. Product does not start 1.1 Battery pack is not
properly attached
1.1 Attach properly
1.2 Battery pack is
discharged
1.2 Remove and charge
battery pack
1.3 Battery pack is hot 1.3 Remove and let it
cool
1.4 Battery pack is
damaged
1.4 Check by a specialist
electrician
1.5 Chain brake is
activated
1.5 Disengage the chain
brake
1.6 Other electrical defect
to the product
1.6 Check by a specialist
electrician
2. Product
does not reach full power
2.1 Battery pack capacity
is too low
2.1 Charge battery pack
2.2 Air vents are blocked 2.2 Clean the air vents
3
Unsatisfactory result
3.1 Saw chain not
tensioned properly
3.1 Tension properly
3.2 Saw chain is dull/
damaged
3.2 Sharpen or replace
the saw chain
3.3 Chain oil tank is
empty
3.3 Rell the chain oil
4. Product suddenly stops 4.1 Battery pack is
discharged
4.1 Remove and charge
battery pack
4.2 Battery pack is too
hot
4.2 Remove battery pack
and let it cool down
4.3 Saw chain is blocked 4.3 Remove blockage
5. Excessive vibration or
noise
5.1 Saw chain is dull/
damaged
5.1 Replace with a new
one
5.2 Bolts/nuts are loosen 5.2 Tighten bolts/nuts
5.3 Chain oil is incorrect 5.3 Drain out unused oil
and rell with correct oil
Troubleshooting
To Next Page
Loading...
