Titan TTI932CHN - Page 40

40
In
more
detail...
EN
TTI932CHN
Fig. 33
3. When the log is supported on both ends (Fig. 34), cut 1/3 the diameter from
the top (overbuck). Then make the nished cut by underbucking the lower
2/3 to meet the rst cut.
Fig. 34
4. When bucking on a slope always stand on the uphill side of the log (Fig.
35). When “cutting through”, to maintain complete control release the
cutting pressure near the end of the cut without relaxing your grip on the
product handles. Don’t let the chain contact the ground. After completing
the cut, wait for the saw chain to stop before you move the product. Always
stop the motor before moving from tree to tree.
Fig. 35
5. Support small logs on a sawing stand or another log while bucking (Fig.
36).
Operation