Important Information
Read these instructions fully before the installation of
this appliance
1. Installation of the appliance and accessories must
be carried out by a qualied and suitably competent
person and be carried out in clean, dry conditions
where dust and humidity are at minimal levels.
2. All wiring must conform to current I.E.E. Wiring
Regulations and all applicable standards and Building
Regulations.
3. Units are suitable for 220-240V~ 50-60Hz single
phase.
4. Stationary appliances not tted with means for
disconnection from the supply mains having a contact
separation in all poles that provide full disconnection
under over voltage category III, the instructions state
that means for disconnection must be incorporated in
the xed wiring in accordance with the wiring rules.
5. If supply is a 6 amp lighting circuit a local fuse is not
required.
6. If supply is not via a 6 amp lighting circuit, a localised
3 amp fuse must be used.
7. The unit must be stored in a clean and dry
environment.
8. Ensure that external grilles are located away from
any ue outlet, in accordance with relevant Building
Regulations.
9. The terminal marked with the earth symbol is for
parking only and non-functional. As the fan is a class
II appliance no connection to earth is required.
Warnings, Safety and Guidance
2
To Next Page
Loading...
