TKO 6610 - Step 2: Attach Seat Pad Support and Front Upright

To Next Page

To Previous Page

─ 11 ─

Assembly

Step 2

1. Attach the Seat Pad Support Receptacle (#2) to Rear Base (#1) and secure

in place using:

three M10 Nylon Lock Nut (#104) six Φ11*Φ20*2 Flat Washer (#102)

three M10*75 BHCS (#94) one Φ11*Φ38*2 Flat Washer (#107)

one Φ10 Spring Washer (#103) one M10*80 BHCS (#95)

2. Connect the Front Upright (#86) to Seat Pad Support Receptacle (#2) and

secure together

using:

two M10 Nylon Lock Nut (#104) four Φ11*Φ20*2 Flat Washer (#102)

two M10*80 BHCS (#95)

3. Insert the Pec Dec Mount (#7) onto Seat Pad Support Receptacle (#2) using:

two M10 Nylon Lock Nut (#104) four Φ11*Φ20*2 Flat Washer (#102)

two M10*75 BHCS (#94) one M10*70 BHCS(#93)

one Φ10 Spring Washer (#103) one Φ11*Φ38*2 Flat Washer (#107)

Note: Hand tighten bolts and Νylon Lock nuts until machine is fully assembled.