Need help?Do you have a question about the TKO 6610 and is the answer not in the manual?
Guidance on safe assembly practices, emphasizing following steps and proper environment.
Lists and illustrates the necessary tools for assembling the equipment.
Details on inserting Guide Rods (#24) into the Rear Base (#1) with specific hardware.
Instructions for attaching Seat Pad Support Receptacle (#2) and Front Upright (#86).
Guidance on installing the Main Upright (#3) onto the Seat Pad Support Receptacle (#2).
Steps for sliding weight stack components and attaching the Main Top Beam (#4).
Instructions for attaching Press Arm Support (#5) and Press Arm (#6) using set screws.
Details on attaching the Right and Left Pec Dec Arms (#8, #9) and Handle Bars (#19).
Instructions for installing the Right and Left Hold Leg Frames (#17, #18) to the Main Upright (#3).
Steps for attaching the Leg Extension Lever (#10) and Foam Frames (#11, #12).
Instructions for attaching the Seat Pad (#26) and Back Pad (#25) assemblies.
Details on installing Upholstered Roller Pads (#42) on foam frames and leg hold frames.
Instructions for installing the Chest Press Cable (#45) with pulleys and hardware.
Instructions for installing the Mid Pulley Cable (#46) with pulleys and hardware.
Instructions for installing the Leg Press Cable Substitute (#47), if applicable.
Instructions for installing the Pec Dec Cable (#49) with pulleys and hardware.
Instructions for connecting Lat Bars (#70, #71) and straps (#40, #34) to cables.
Details on installing Weight Shrouds (#20) to the Main Top Beam and Rear Frame.
Details on the equipment's class and maximum load capacity.
To Next Page
General