─ 20 ─
Assembly
Step 11
Note: Stretch all cables out completely and make sure all twisting is removed
before installing.
1. Install Chest Press Cable (#45) as detailed in Figure 11. Follow dotted lines
to identify exact location of pulleys. See Page 29 "Cable View" for more detail.
2. Start by threading cable end into Top Plate (#27).
3. You will need the following for installation:
eight Pulley (#44) one Cable (#45)
nine M10 Nylon Locknut (#104) six Long Pulley Spacer (#53)
four Longer Pulley Spacer (#55) one Adjustable Stopper (#75)
two M10*50 BHCS (#90) two M10*45 BHCS (#91)
three M10*70 BHCS (#93) two M10*80 BHCS (#95)
eighteen Φ11*Φ20*2 Flat Washer (#102) one M10 Regular Hex Nut (#100)
one Small Pulley (#120)
Note: Hand tighten bolts and Nylon Lock nuts until machine is fully assembled.
Step 12
Note: Stretch all cables out completely and make sure all twisting is removed
before installing.
Install Mid Pulley Cable (#46) as detailed in Figure 12. Follow dotted lines to
identify exact location of pulleys. See Page 29 "Cable View" for more detail.
Start by installing cable under the pulley at Leg Extension location.
You will need the following for installation:
seven Pulley (#44) one Cable (#46)
eight M10 Nylon Locknut (#104) six Long Pulley Spacer (#53)
four Longer Pulley Spacer (#55) two Short Pulley Spacer (#54)
eighteen Φ11*Φ20*2 Flat Washer (#102) three M10*45 BHCS (#91)
one M10*65 BHCS (#92) one M10*70 BHCS (#93)
one M10*75 BHCS (#94) one M10*80 BHCS (#95)
one Pulley Bracket w/ Shaft (#21) one Pulley Bracket Block (#22)
one Pulley Bracket (#23) one Cable Rtainer Bracket (#78)
one Small Pulley (#120)
Note: Hand tighten bolts and Nylon Lock nuts until machine is fully assembled.
To Next Page
Loading...